FF
➀ Print and return to standard mode in page mode
➁ Print and feed marked paper to print starting position
➀ When page mode is selected:
Prints the data in the print buffer collectively and returns to standard
mode
This command is enabled only in page mode.
The buffer data is deleted after being printed.
The printing area set by ESC W is reset to the default setting.
This command sets the print position to the beginning of the line.
➁ When BM sensor is effective:
Prints the data in the print buffer and feeds marked paper to the
print starting position.
This command is enabled only when the BM sensor is set to be
effective using with DIP SW1-1.
This command sets the print position to the beginning of the line.
If this command is executed at the print starting position of the
marked paper, the printer feeds the marked paper to the next print
starting position.
ESC FF
Print data in the page mode
Print all buffered data in the printable area collectively in page mode.
1) This command is enable only in page mode.
2) When using label paper, when this command is executed, label location is
not executed.
3) The butter data,
ESC T
and
ESC W
set and character set are not deleted after
printing.