HPRT TP80K Programming Manual

1
1 Basic Setting Commands
ESC @
[Name]
Initialize printer
[Format]
ASCII
ESC @
Hex
1B 40
Decimal
27 64
[Description]
Clears the data in the print buffer and resets the printer mode to the mode that
was in effect when the power was turned on.
[Notes]
The DIP switch and memory switch settings are not checked again.
The data in the receive buffer is not cleared.
The macro definition is not cleared.
GS P x y
[Name]
Set horizontal and vertical motion units
[Format]
ASCII
GS P x y
Hex
1D 50 x y
Decimal
29 80 x y
[Range]
0 ≤ x ≤ 255
0 ≤ y ≤ 255
[Description]
Sets the horizontal and vertical motion units to approximately 25.4/x mm
{1/x"} and
approximately 25.4/y mm {1/y"}, respectively.
• When x = 0, the default value of the horizontal motion unit is used.
• When y = 0, the default value of the vertical motion unit is used.
[Default]
x=203,y=406
ESC 2
[Name]
Set the default line spacing
[Format]
ASCII
ESC 2
Hex
1B 32
Decimal
27 50
[Description]
Selects 3.75 mm (30 × 0.125 mm) line spacing.
[Notes]
The line spacing can be set independently in standard mode and in page mode.

HPRT TP80K Specifications

General

Brand	HPRT
Model	TP80K
Category	Printer
Language	English