Set print position to the
beginning
of print
line
In standard mode, moves the print position to the beginning of the print line
after performing the operation specified by n.
Cancel data in the current print buffer
Print data in the current print buffer
■
In page mode, this command is
ignored.
■
This command is ignored
if
t
he
print position is already the
beginning
of the
line.
■
If the print position is not set to the
beginning
of the line, when n
= 1, 49, this command functions
the
same
as
L
F
.
■
Setting values of each command,
definitions,
and receive
buffer
content are not
changed.
■
By processing this command, the
print
position moves to the left of
the print area. The
printer
will be
in
the
beginning
of the line and data
will not be in
t
h
e print
buf
f
e
r
.
■
When using commands that are enabled only at the
beginning
of the
line, these commands are sure to
be
executed
if
GS T is used
immediately
before using those
commands.
To Next Page
Loading...
Need help?
General
