This command is enabled only when processed at the beginning of a line in
standard mode.
This command has no effect in page mode.
After printing by FF is completed or by using ESC S, the printer returns to
standard mode.
This command sets the position where data is buffered to the position
specified by ESC T within the printing area defined by ESC W.
This command switches the settings for the following commands (in which the
values can be set independently in standard mode and page mode) to those for
page mode:
①
Set right-side character spacing: ESC SP, FS S
②
Select default line spacing: ESC 2, ESC 3
Only valve settings is possible for the following commands in page mode; these
commands are not executed.
①
Turn 90°clockwise rotation mode on/off: ESC V
②
Select justification: ESC a
③
Turn upside-down printing mode on/off: ESC {
④
Set left margin: GS L
⑤
Set printable area width: GS W
The printer returns to standard mode when power is turned on, the printer is
reset, or ESC @ is used.
To Next Page
Loading...
Need help?
General
