■
The maximum paper feed amount depends on the
printer
model.
■
After
printing,
the print position moves to the
beginning
of
the line. When a left margin is set,
the
position of the left margin is
the
beginning
of the
line.
■
When standard mode is selected, the vertical
motion
unit is used.
■
When page mode is selected, the vertical or
horizontal motion
unit is
used for
t
he
print
direction
set
by
ESC
T
.
•
When the starting position is set to the upper left or lower right of
t
he
print area using ESC T,
the
vertical
motion
unit is used.
•
When the starting position is set to the upper right or lower
left
of
the print area using ESC T,
the horizontal motion
unit is used.
■
When this command is processed in page mode, only the print
position moves; the
printer
does
not
perform
actual
printing.
■
This command is used to
temporarily
feed a specific length
without
changing the line spacing set by
other
command
s.
After printing is completed, this command sets the print starting position to
the beginning of the line.
The paper feed amount set by this command does not affect the values set by
ESC 2 or ESC 3.
To Next Page
Loading...
Need help?
General
