HPRT TP80K

17
GS \ nL nH
[Name]
Set relative vertical print position in page mode.
[Format]
ASCII
GS \ nL nH
Hex
1D 5C nL nH
Decimal
29 92 nL nH
[Range]
0 ≤ nL ≤ 255 0 ≤ nH ≤ 255
[Description]
Sets the relative vertical print starting position from the current position in
page mode.
This command sets the distance from the current position to
[(nL + nH × 256)× 0.125 mm (0.0049”)].
[Notes]
This command is ignored unless page mode is selected.
When pitch N is specified for the movement downward:
nL + nH × 256 = N
When pitch N is specified for the movement upward (the negative
direction),use the complement of 65536.
When pitch N is specified for the movement upward:
nL + nH × 256 = 65536 - N
Any setting that exceeds the specified printing area is ignored.
This command functions as follows, depending on the print starting position
set by ESC T:
①When the starting position is set to the upper left or lower right of the
printing, the vertical motion unit (y) is used.
②When the starting position is set to the upper right or lower left of the
printing area, the horizontal motion unit (x) is used.