HPRT TP80K Programming Manual

7
ESC d n
[Name]
Print and feed n lines
[Format]
ASCII
ESC d n
Hex
1B 64 n
Decimal
27 100 n
[Range]
0 ≤n ≤ 255
[Description]
Prints the data in the print buffer and feeds n lines.
[Notes]
This command sets the print starting position to the beginning of the line.
This command does not affect the line spacing set by ESC 2 or ESC 3.
The maximum paper feed amount is 2032 mm. If the paper feed amount (n
×line spacing) of more than 2032 mm is specified, the printer feeds the paper
only 2032 mm .
[Reference]
ESC 2, ESC 3
ESC e
[Name]
Print and reverse feed n lines
[Format]
ASCII
ESC
e
n
Hex
1B
65
n
Decimal
27
101
n
[Default]
None
[Description]
Prints the data in the print buffer and feeds n lines in the reverse
direction.
[Notes]
■ The amount of paper fed per line is based on the value set using the line
spacing command (ESC 2 or ESC 3 ).
■ The maximum paper feed amount depends on the printer model.
■ After printing, the print position moves to the beginning of
the line. When a left margin is set, the position of the left
margin is the beginning of the line.
■ When this command is processedin page mode, only t he print
position moves, and the printer does not perform actual printing.
■ This command is used to temporarily feed a specific line without
changing the line spacing set by other command s.

HPRT TP80K Specifications

General

Brand	HPRT
Model	TP80K
Category	Printer
Language	English