HPRT TP80K Programming Manual

27
FS S n1 n2
[Name]
Set Kanji character s p ac ing
[Format]
ASCII
FS S n1 n2
Hex
1C 53 n1 n2
Decimal
28 83 n1 n2
[Range]
0 ≤ n1 ≤ 255; 0 ≤ n2 ≤ 255
[Description]
Sets left- and right-side spacing of the multi-byte code character n1 and n2,
respectively .
• S et the left-side character spacing to [n1 × horizontal or vertical motion
units].
• S et the right-side character spacing to [n2 × horizontal or vertical motion
units].
[Notes]
■ Settings of this command affect multilingual characters and user-defined
characters.
■ When a character sizeisset to N ti mes as large as a normal size,both right-
and left-side character spacings are also set to N times as large as a normal
size.
■ In standard mode, the horizontal motion unit (perpendicular to the
paper feed direction) is used.
■ In page mode, the horizontal or vertical motion unit dif f ers, depending
on the starting position set by ESC T .
• When the starting position is set to the upper left or lower right, the
horizontal motion unit (perpendicular to the paper feed direction) is used.
• When the starting position is set to the upper right or lower left, the
vertical motion unit (paper feed direction) is used.
■ Different character spacing can be set for standard mode and page mode.
• When this command is set in standard mode, character spacing for
multilingual (except Thai) characters printed in standard mode is set.
• When this command is set in page mode, character spacing for
multilingual (except Thai) characters printed in page mode is set.
■ If the horizontal or vertical motion unit is changed after setting the
character spacing, the spacing between the characters is not changed.
■ The character spacing is effective until ESC @ is executed, the printer is
reset, or t he power is turned off.
■ This command is used to change spacing between characters.
[Default]
n1=0, n2=0

HPRT TP80K Specifications

General

Brand	HPRT
Model	TP80K
Category	Printer
Language	English