Step 3 On the Uncreated Device Information page, click Access in the Operation
column.
Step 4 In the Device Integration dialog box, set ECC800-Pro device parameters by
referring to Figure 5-90, and click OK.
On the Progress page, view task information, including Type, Device Name,
Region, Progress, Status, Start Time, End Time, and Information. View
operation details in the Information area.
● After a management domain is successfully bound to the ECC800-Pro, all devices under the
ECC800-Pro are displayed on the Planning Conguration page. You can manually change
the device names. However, devices under the ECC800-Pro cannot be moved or deleted.
Instead, you can delete the ECC800-Pro, and all devices under it will be synchronously
deleted.
● The following lists the management domains that can be bound to ECC800-Pros of
dierent
system types:
– The ECC800-Pro whose system type is FusionModule500 can be bound to a
FusionModule500 management domain.
– The ECC800-Pro whose system type is FusionModule800, FusionModule2000, or
FusionModule5000 can be bound to a smart module.
● After room-level monitoring is set on the ECC800-Pro, the access actuators and cameras
synchronized to the NetEco are displayed in the same positions of the smart module (smart
module created in the equipment room, site, subnet, or union container) as those on the
ECC800-Pro. After the access actuators and cameras are deleted from the ECC800-Pro, the
access actuators and cameras synchronized to the NetEco are displayed only in the
undeployed device list of the smart module.
Figure 5-90 Adding the ECC800-Pro devices by automatic discovery
FusionModule2000-S Smart Modular Data Center
User Manual 5 Power-On Commissioning
Issue 07 (2022-09-30) Copyright © Huawei Technologies Co., Ltd. 267
To Next Page
Loading...
Need help?
General