● If the cabinet installation environment is in poor condition, to well store the
cabinet after it is unpacked, take measures to prevent dust. You can wrap the
cabinet with the original plastic coat.
Do not tear down the transparent lm from the glass door during the installation.
The lm will be removed after the entire module is installed.
Procedure
Step 1 Use a pallet truck to transport the cabinet to the installation position.
Step 2 Check that the cabinet package is intact.
Step 3 Cut
o and remove the binding straps, and remove the packing.
Step 4 Remove pallets from ordinary cabinets.
1. Remove the plastic bag and take out the
tting box.
2. Check the cabinet exterior for damage. If any damage is found, notify the
carrier immediately.
3. Check against the packing list that the equipment and
ttings are correct and
complete. If some ttings are missing or do not comply with the packing list,
record the information and contact your local Huawei
oce immediately.
4. After checking that the cabinet is intact, remove the screw assemblies that
secure the cabinet to the pallet, as shown in Figure 4-2.
Set the screw assemblies aside for they will be used in installation steps.
FusionModule500 Smart Mini Data Center
User Manual 4 Installation Guide
Issue 02 (2020-12-25) Copyright © Huawei Technologies Co., Ltd. 64
To Next Page
Loading...
Need help?
General