Installation Manual
Quidway S8500 Series Routing Switches Chapter 4 Switch Installation
Huawei Technologies Proprietary
4-17
Figure 4-17 Install cabling rack
4.7 Installing Fan Tray
The fan tray is hot swappable.
Caution:
In case of bodily injuries, do not touch any naked wire, terminal or other parts of the
product with hazardous voltage labels.
Step 1: Wear the ESD-preventive wrist strap, making sure that it makes good skin
contact; take the fan tray out from the packing bag.
Step 2: Hold the fan tray in right direction (just check the direction of instructional words,
and if you insert it upside down, the plug of the fan tray cannot touch the right socket
inside the chassis), with one hand on its handle and the other hand at its bottom the
ejector levers on the fan tray with both hands and pull them outward. Align the fan tray
with the guides in the chassis and slide it gently into the slot until its plug touches the
chassis socket.
Step 3: Fasten the mounting screws on the panel of the fan tray with a screw driver.
To Next Page
Loading...
Need help?
General