Installation Manual
Quidway S8500 Series Routing Switches Chapter 5 System Debugging
Huawei Technologies Proprietary
5-5
5.2.3 Verifying after Power-on (Recommended)
To ensure the configuration works that you will make on the switch, you are
recommended to check the switch after powering it on to make sure that:
z
The cooling system is working. In this case, you can hear the noise caused by fan
rotation and feel that there is air exhausted out.
z
All the system LEDs on the SRPUs function normal.
5.2.4 Boot Interface
The S8505 switch is used as an example in this section.
The following is the information that will be output at the Console terminal when you
power on and boot the switch.
ZBB_TEST
Starting...
******************************************
* *
* Quidway S8500 Bootrom, Version 106 *
* *
******************************************
Copyright(C) 2001-2005 by HUAWEI TECHNOLOGIES CO.,LTD.
Creation date: Jun 6 2003, 19:28:01
CPU type : MPC755
CPU L2 Cache : 1024KB
CPU Clock Speed : 400MHz
BUS Clock Speed : 100MHz
Memory Size : 512MB
Flash file system init....done
S8500 LSB1SRPA board self testing...........................
The board is steady
SlotNo of this LSB1SRPA is 0
BootRom main system CRC check is OK
82559 register testing is OK
EPLD1 testing is OK
EPLD2 testing is OK
16c2552 register testing is OK
Please check LEDs......................LED testing finished
The switch Mac address is 00e0.fc00.00a1
Press Ctrl+B to enter Boot Menu... 0
Auto-booting...
To Next Page
Loading...
Need help?
General