Installation Manual
Quidway S8500 Series Routing Switches Chapter 6 Switch Monitoring and Maintenance
Huawei Technologies Proprietary
6-23
Trying ...
Press CTRL+K to abort
Connected.
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User(none):8500
331 Give me your password, please
Password:
230 Logged in successfully
[ftp] get SWITCH002.app SWITCH002.app
[ftp] get Switchbtm.btm Switchbtm.btm
[ftp] bye
Note:
If the switch has two SRPUs, you also can copy the host and Boot ROM program files
to the standby SPPU.
Step 2: Specify the next boot program. If the switch has two SRPUs, specify the load
programs respectively for the active and standby SRPUs. Suppose the current standby
SRPU is at slot 7.
z
Load Boot ROM program
<Quidway> boot bootrom flash:/Switchbtm.btm slot 6
<Quidway> boot bootrom slot7#flash:/Switchbtm.btm slot 7
z
Load host program
<Quidway> boot boot-loader flash:/SWITCH002.app
<Quidway>boot boot-loader slot7#flash:/SWITCH002.app
Note:
The URL form of the files in the standby SRPU file system must start with
“slot[No.]#flash:/”, where [No.] is the standby SRPU number.
<Quidway> display boot-loader
The app to boot of board 6 at the next time is: flash:/SWITCH002.app
The app to boot of board 6 at this time is: flash:/SWITCH002.app
The app to boot of board 7 at the next time is: flash:/SWITCH002.app
The app to boot of board 7 at this time is: flash:/SWITCH002.app
To Next Page
Loading...
Need help?
General