Huawei UPS5000-E-30 kVA - Page 182

Alarm ID
(Alarm ID-
Cause ID)
Alarm
Name
Alarm
Severity
Causes Solution
0004-1 Mains ph.
reversed
Minor Cable
connections are
incorrect.
Check cable connections.
0005-1 Mains
neutral
absent
Minor Cable
connections are
incorrect.
1. Secure or connect the neutral wire
to the cabinet if it is loose or
disconnected.
2. Check that the neutral wire to the
power distribution system is
normal.
0006-1 Mains
undervoltage
Minor ● The mains is
abnormal.
● The power
module
sampling
circuit is
abnormal.
Check whether the mains voltage
ranges from 80 V (excluding 80 V) to
176 V with a multimeter. If no, the
mains monitoring circuit of the power
module is faulty. Replace the faulty
power module.
0010-1 Abnormal
BPS volt.
Minor ● The bypass
voltage range
is incorrectly
set.
● The bypass
input voltage
is abnormal.
1. Check the bypass input voltage or
cable connections with a
multimeter.
2. Check the voltage system and
bypass voltage thresholds
congured on the LCD.
0010-2 ● The bypass
frequency
range is
incorrectly
set.
● The bypass
input
frequency is
abnormal.
1. Check the bypass input voltage or
cable connections with a
multimeter.
2. Check the bypass input frequency.
Check the rated frequency and
frequency range
congured on the
LCD.
0011-1 BPS phase
reverse
Minor The phase
sequence of the
three-phase
bypass input is
reversed.
Check whether the cable phase
sequence is correct with a multimeter.
If no multimeter is available, exchange
the positions of any two cables.
0012-1 Bypass
neutral
absent
Minor The bypass
input neutral
wire is lost.
1. Secure or connect the neutral wire
to the cabinet if it is loose or
disconnected.
2. Check that the neutral wire to the
power distribution system is
normal.
UPS5000-E-(30 kVA–180 kVA)
User Manual (Integrated UPS) B Alarm List
Issue 02 (2022-12-30) Copyright © Huawei Digital Power Technologies Co., Ltd. 174