38/LUBRICATION SYSTEM 159
– Place the motorcycle upright on a horizontal surface (not on the side stand).
100454-10
– Place a suitable container under the engine.
– Remove oil drain plug with the magnet and seal ring.
100452-10
– Remove engine oil screen plug with engine oil screen .
– Completely drain the engine oil.
100453-10
– Remove banjo bolt with the oil screen.
– Thoroughly clean the parts and sealing surfaces.
– Mount and tighten banjo bolt with the oil screen and seals.
Guideline
Banjo bolt, oil line M12 15 Nm
(11.1 lbf ft)
– Oil the O-rings on the engine oil screen and insert them in the engine oil screen
plug. Mount and tighten the engine oil screen plug.
Guideline
Plug, engine oil screen M17x1.5 20 Nm
(14.8 lbf ft)
– Mount and tighten the oil drain plug with the magnet and seal ring.
Guideline
Oil drain plug with magnet M12x1.5 20 Nm
(14.8 lbf ft)
23.7Removing the oil filter
Warning
Danger of scalding Engine oil and gear oil get very hot when the motocycle is driven.
– Wear suitable protective clothing and protective gloves. If you get scalded, immediately flush the affected areas with luke-
warm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
– Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
– Place a suitable container under the engine.
100455-10
– Remove screws . Remove oil filter cover with the O-ring.
– Pull oil filter out of the oil filter housing.
Circlip pliers reverse (51012011000) ( p. 268)
– Completely drain the engine oil.
To Next Page