HUSABERG FE 570 EU - Removing the Heim Joint; Installing the Heim Joint

04/SHOCK ABSORBER, SWINGARM 41
7.19Removing the heim joint
Condition
The shock absorber has been demounted.
200799-10
– Clamp shock absorber in a bench vise using soft jaws.
– Remove the collar bushing of the heim joint with a punch.
– Turn the shock absorber around and remove the second heim joint collar bushing
with a punch.
200800-10
– Remove seal ring  on both sides.
200801-10
– Press the heim joint against a lock ring using the special tool.
Pressing tool (T1207S) ( p. 275)
– Remove the second lock ring .
200802-10
– Place special tool  below and press out heim joint  using special tool .
Pressing tool (T1207S) ( p. 275)
7.20Installing the heim joint
200803-10
– Position new heim joint  and special tool.
Pressing tool (T1206) ( p. 275)
– Press in the heim joint all the way.