HUSABERG FE 570 EU - Performing a Shock Absorber Service; Removing the Spring

04/SHOCK ABSORBER, SWINGARM 35
7.11Performing a shock absorber service
Condition
The shock absorber has been removed.
200989-01
– Remove the spring. ( p. 35)
– Disassemble the shock absorber. ( p. 36)
– Disassemble the piston rod. ( p. 37)
– Disassemble the seal ring retainer. ( p. 38)
– Check the shock absorber. ( p. 39)
– Disassemble the rebound adjuster. ( p. 40)
– Remove the heim joint. ( p. 41)
– Install the heim joint. ( p. 41)
– Assemble the rebound adjuster. ( p. 42)
– Assemble the seal ring retainer. ( p. 43)
– Assemble the piston rod. ( p. 43)
– Assemble the shock absorber. ( p. 45)
– Install the spring. ( p. 50)
7.12Removing the spring
Condition
The shock absorber has been demounted.
– Clamp the shock absorber in a bench vise using soft jaws.
– Measure and note the spring length in its pre-compressed state.
200750-10
– Unscrew screw .
– Rotate the adjusting ring until the spring is no longer under tension.
Hook wrench (T106S) ( p. 274)
200751-10
– Remove O-ring .
– Remove spring retainer  and intermediate washer .
– Remove the spring.
200752-10
– Rotate adjusting ring  with the intermediate washer toward the top.
Info
Both cannot be taken off yet.