HUSABERG FE 570 EU - 11;Wiring Harness, Battery; Disconnecting the Negative Cable of the Battery; Connecting the Negative Cable of the Battery; Changing the Main Fuse

11/WIRING HARNESS, BATTERY 73
14.1Disconnecting the negative cable of the battery
– Switch off all power consumers and the engine.
– Remove the seat. ( p. 59)
300675-10
– Disconnect negative cable  of the battery.
Info
Pay attention to the contact disks between the cable sockets and battery
terminals.
14.2Connecting the negative cable of the battery
300675-10
– Connect negative cable .
Info
Contact disks  must be mounted between battery terminals  and cable
sockets  with the claws facing up.
100424-10
– Tighten the screw.
Guideline
Screw, battery terminal M5 3 Nm (2.2 lbf ft)
14.3Changing the main fuse
Warning
Fire hazard The electrical system can be overloaded by the use of incorrect fuses.
– Use only fuses with the prescribed amperage. Never by-pass or repair fuses.
Info
The main fuse protects all power consumers of the vehicle. It is located in the housing of the starter relay on the battery cover.
– Switch off all power consumers and switch off the engine.
– Remove the seat. ( p. 59)
100426-10
– Detach connector .
– Remove protection covers .