11/WIRING HARNESS, BATTERY 77
100425-10
– Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (81229074000)
You can also use the battery charger to check the off load voltage, the starting abil-
ity of the battery and the generator. The device also makes it impossible to over-
charge the battery.
Info
Never remove cover .
Charge the battery with a maximum of 10% of the capacity specified on
battery housing .
– Switch off the battery charger after charging.
Guideline
Charging current, charging voltage and charging time may not be exceeded.
Recharge the battery regularly if the
motorcycle is not put into operation
3 months
Tip
If the vehicle is not ridden for more than two weeks, we recommend trickle
charging the battery with the HUSABERG battery charger. The battery is
first charged completely and then maintained at this level over the subse-
quent period. Thus, the battery is always fully charged when the vehicle is
put into operation.
– Connect the negative cable.
Info
Contact disk must be mounted between battery terminal and cable
socket with the claws facing up.
– Tighten the screw.
Guideline
Screw, battery terminal M5 3 Nm (2.2 lbf ft)
– Mount the seat. ( p. 59)
To Next Page
Loading...
