© Copyright IBM Corp. 2011 Chapter 11. Quality of Service 137
DSCP Re-Marking and Mapping
The switch can use the DSCP value of ingress packets to re-mark the DSCP to a
new value, and to set an 802.1p priority value. Use the following command to view
the default settings.
Use the following command to turn on DSCP re-marking globally:
Then you must enable DSCP re-marking on any port that you wish to perform this
function (Interface Port mode).
Note: If an ACL meter is configured for DSCP re-marking, the meter function takes
precedence over QoS re-marking.
RS G8000# show qos dscp
Current DSCP Remarking Configuration: OFF
DSCP New DSCP New 802.1p Prio
-------- -------- ---------------
0 0 0
1 1 0
2 2 0
3 3 0
4 4 0
5 5 0
6 6 0
7 7 0
8 8 1
9 9 0
10 10 1
...
54 54 0
55 55 0
56 56 7
57 57 0
58 58 0
59 59 0
60 60 0
61 61 0
62 62 0
63 63 0
RS G8000(config)# qos dscp re-marking
To Next Page
Loading...
Need help?
General
