IBM RackSwitch G8000

© Copyright IBM Corp. 2011 Chapter 28. Remote Monitoring 335
Configuring RMON History
Perform the following steps to configure RMON History on a port.
1. Enable RMON on a port.
2. Configure the RMON History parameters for a port.
where <x> is the number of the port to monitor. For example, the full OID for port
1 would be:
1.3.6.1.2.1.2.2.1.1.1
3. View RMON history for the port.
RS G8000(config)# interface port 1
RS G8000(config-if)# rmon
RS G8000(config-if)# exit
RS G8000(config)# rmon history 1 interface-oid
1.3.6.1.2.1.2.2.1.1.<x>
RS G8000(config)# rmon history 1 requested-buckets 30
RS G8000(config)# rmon history 1 polling-interval 120
RS G8000(config)# rmon history 1 owner "rmon port 1 history"
RS G8000(config)# show rmon history
RMON History group configuration:
Index IFOID Interval Rbnum Gbnum
----- ----------------------- -------- ----- -----
1 1.3.6.1.2.1.2.2.1.1.1 120 30 30
Index Owner
----- ----------------------------------------------
1 rmon port 1 history