IBM RackSwitch G8000

238 RackSwitch G8000: Application Guide
Static Multicast Router
A static Mrouter can be configured for a particular port on a particular VLAN. A static
Mrouter does not have to be learned through IGMP Snooping. Any data port can
accept a static Mrouter.
When you configure a static Mrouter on a VLAN, it replaces any dynamic Mrouters
learned through IGMP Snooping.
Configure a Static Multicast Router
1. For each Mrouter, configure a port, VLAN, and IGMP version.
The IGMP version is set for each VLAN, and cannot be configured separately for
each Mrouter.
2. Verify the configuration.
RS G8000(config)# ip igmp mrouter 5 1 2
RS G8000(config)# show ip igmp mrouter