IBM RackSwitch G8000 User Manual

58 RackSwitch G8000: Application Guide
To Copy the Switch Image and Boot Files to the SCP Host
Syntax :
Example:
To Load Switch Configuration Files from the SCP Host
Syntax:
Example:
SSH and SCP Encryption of Management Messages
The following encryption and authentication methods are supported for SSH and
SCP:
• Server Host Authentication:Client RSA authenticates the switch at the
beginning of every connection
• Key Exchange: RSA
• Encryption:3DES-CBC, DES
• User Authentication:Local password authentication, RADIUS, SecurID (via
RADIUS or TACACS+ for SSH only—does not apply to SCP)
Generating RSA Host Key for SSH Access
To support the SSH host feature, an RSA host key is required. The host key is 1024
bits and is used to identify the G8000.
To configure RSA host key, first connect to the G8000 through the console port
(commands are not available via external Telnet connection), and enter the
following command to generate it manually.
When the switch reboots, it will retrieve the host key from the FLASH memory.
Note: The switch will perform only one session of key/cipher generation at a time.
Thus, an SSH/SCP client will not be able to log in if the switch is performing
key generation at that time. Also, key generation will fail if an SSH/SCP client
is logging in at that time.
>> scp [-4|-6] <username>@<switch IP address>:getimg1 <local filename>
>> scp [-4|-6] <username>@<switch IP address>:getimg2 <local filename>
>> scp [-4|-6] <username>@<switch IP address>:getboot <local filename>
>> scp scpadmin@205.178.15.157:getimg1 6.1.0_os.img
>> scp [-4|-6] <local filename> <username>@<switch IP address>:putimg1
>> scp [-4|-6] <local filename> <username>@<switch IP address>:putimg2
>> scp [-4|-6] <local filename> <username>@<switch IP address>:putboot
>> scp 6.1.0_os.img scpadmin@205.178.15.157:putimg1
RS G8000(config)# ssh generate-host-key

IBM RackSwitch G8000 Specifications

General

Brand	IBM
Model	RackSwitch G8000
Category	Network Router
Language	English