© Copyright IBM Corp. 2011 Chapter 2. Initial Setup 37
4. Enter the day of the current date at the prompt:
Enter the date as a number from 1 to 31. To keep the current day, press <Enter>.
The system displays the date and time settings:
5. Enter the hour of the current system time at the prompt:
Enter the hour as a number from 00 to 23. To keep the current hour, press
<Enter>.
6. Enter the minute of the current time at the prompt:
Enter the minute as a number from 00 to 59. To keep the current minute, press
<Enter>.
7. Enter the seconds of the current time at the prompt:
Enter the seconds as a number from 00 to 59. To keep the current second, press
<Enter>. The system then displays the date and time settings:
8. Turn Spanning Tree Protocol on or off at the prompt:
Enter
y
to turn off Spanning Tree, or enter
n
to leave Spanning Tree on.
Setup Part 2: Port Configuration
Note: When configuring port options for your switch, some prompts and options
may be different.
1. Select whether you will configure VLANs and VLAN tagging for ports:
If you wish to change settings for VLANs, enter
y
, or enter
n
to skip VLAN
configuration.
Enter day [3]:
System clock set to 18:55:36 Wed Jan 28, 2009.
System Time:
Enter hour in 24-hour format [18]:
Enter minutes [55]:
Enter seconds [37]:
System clock set to 8:55:36 Wed Jan 28, 2009.
Spanning Tree:
Current Spanning Tree Group 1 setting: ON
Turn Spanning Tree Group 1 OFF? [y/n]
Port Config:
Will you configure VLANs and VLAN tagging for ports? [y/n]
To Next Page
Loading...
Need help?
General
