192 RackSwitch G8000: Application Guide
IPv6 Limitations
The following IPv6 features are not supported in this release.
• Dynamic Host Control Protocol for IPv6 (DHCPv6)
• Border Gateway Protocol for IPv6 (BGP)
• Routing Information Protocol for IPv6 (RIPng)
Most other IBM Networking OS 6.8 features permit IP addresses to be configured
using either IPv4 or IPv6 address formats. However, the following switch features
support IPv4 only:
• Default switch management IP address
• SNMP trap host destination IP address
• Bootstrap Protocol (BOOTP) and DHCP
• RADIUS, TACACS+ and LDAP
• QoS metering and re-marking ACLs for out-profile traffic
•Stacking
• VMware Virtual Center (vCenter) for VMready
• Routing Information Protocol (RIP)
• Internet Group Management Protocol (IGMP)
• Border Gateway Protocol (BGP)
• Virtual Router Redundancy Protocol (VRRP)
•sFlow
To Next Page
Loading...
Need help?
General
