© Copyright IBM Corp. 2011 Chapter 27. Simple Network Management Protocol 327
Switch Images and Configuration Files
This section describes how to use MIB calls to work with switch images and
configuration files. You can use a standard SNMP tool to perform the actions, using
the MIBs listed in Table 26.
Table 26 lists the MIBS used to perform operations associated with the Switch
Image and Configuration files.
The following SNMP actions can be performed using the MIBs listed in Table 26.
•
Load a new Switch image (boot or running) from a FTP/TFTP server
•
Load a previously saved switch configuration from a FTP/TFTP server
•
Save the switch configuration to a FTP/TFTP server
•
Save a switch dump to a FTP/TFTP server
Table 26. MIBs for Switch Image and Configuration Files
MIB Name MIB OID
agTransferServer 1.3.6.1.4.1872.2.5.1.1.7.1.0
agTransferImage 1.3.6.1.4.1872.2.5.1.1.7.2.0
agTransferImageFileName 1.3.6.1.4.1872.2.5.1.1.7.3.0
agTransferCfgFileName 1.3.6.1.4.1872.2.5.1.1.7.4.0
agTransferDumpFileName 1.3.6.1.4.1872.2.5.1.1.7.5.0
agTransferAction 1.3.6.1.4.1872.2.5.1.1.7.6.0
agTransferLastActionStatus 1.3.6.1.4.1872.2.5.1.1.7.7.0
agTransferUserName 1.3.6.1.4.1872.2.5.1.1.7.9.0
agTransferPassword 1.3.6.1.4.1.1872.2.5.1.1.7.10.0
agTransferTSDumpFileName 1.3.6.1.4.1.1872.2.5.1.1.7.11.0
To Next Page
Loading...
Need help?
General
