To Next Page

To Previous Page

158 RackSwitch G8000: Application Guide

The

Update Image/Cfg

section of the window applies to the Master. When a new

software image or configuration file is loaded, the file first loads onto the Master, and

the Master pushes the file to all other switches in the stack, placing it in the same

software or configuration bank as that on the Master. For example, if the new image

is loaded into image 1 on the Master switch, the Master will push the same firmware

to image 1 on each Member switch.

Reboot Master Performs a software reboot/reset of the Master switch. The

software image specified in the Image To Boot drop-down list

becomes the active image.

Reboot Switches Performs a reboot/reset on selected switches in the stack.

Select one or more switches in the drop-down list, and click

Reboot Switches. The software image specified in the Image To

Boot drop-down list becomes the active image.

Table 15. Stacking Boot Management buttons (continued)

Field Description

Other manuals for IBM RackSwitch G8000

Questions and Answers:

Need help?

Do you have a question about the IBM RackSwitch G8000 and is the answer not in the manual?

General