276 RackSwitch G8000: Application Guide
9. Configure the virtual link.
The
nbr
router ID configured in this step must be the same as the router ID that
was configured for switch #1 in Step 2 on page 273.
Other Virtual Link Options
•
You can use redundant paths by configuring multiple virtual links.
•
Only the endpoints of the virtual link are configured. The virtual link path may
traverse multiple routers in an area as long as there is a routable path between
the endpoints.
RS G8000(config)# router ospf
RS G8000(config-router-ospf)# area-virtual-link 1 area 1
RS G8000(config-router-ospf)# area-virtual-link 1 neighbor-router
10.10.10.1
RS G8000(config-router-ospf)# area-virtual-link 1 enable
To Next Page
Loading...
