316 RackSwitch G8000: Application Guide
Using the CLI the following command displays remote LLDP information:
To view a summary of remote information, omit the
Index number
parameter. For
example:
To view detailed information for a remote device, specify the
Index number
as found
in the summary. For example, in keeping with the sample summary, to list details for
the first remote device (with an
Index
value of 1), use the following command:
Note: Received LLDP information can change very quickly. When using show
commands, it is possible that flags for some expected events may be too
short-lived to be observed in the output.
RS G8000(config)# show lldp remote-device [<index number>]
RS G8000(config)# show lldp remote-device
LLDP Remote Devices Information
LocalPort | Index | Remote Chassis ID | Remote Port | Remote System
Name
----------|-------|----------------------|-------------|--------------
-------
3 | 1 | 00 18 b1 33 1d 00 | 23 |
RS G8000(config)# show lldp remote-device 1
Local Port Alias: 3
Remote Device Index : 1
Remote Device TTL : 99
Remote Device RxChanges : false
Chassis Type : Mac Address
Chassis Id : 00-18-b1-33-1d-00
Port Type : Locally Assigned
Port Id : 23
Port Description : 7
System Name :
System Description : BNT 1/10Gb Uplink Ethernet Switch Module,
flash image: version 5.1.0,
boot image: version 5.1.0.12
System Capabilities Supported : bridge, router
System Capabilities Enabled : bridge, router
Remote Management Address:
Subtype : IPv4
Address : 10.100.120.181
Interface Subtype : ifIndex
Interface Number : 128
Object Identifier :
To Next Page
Loading...
Need help?
General
