IBM Storwize V7000 - Page 182

Ensure that space is available in a standard 19" rack that is capable of supporting the enclosure. The rack
rail kit supports racks with either threaded round or square rail mounting holes. The following table lists
the dimensions and weights of the enclosures.
Table 25. Physical characteristics of the enclosures
Enclosure Height Width Depth
Maximum weight
Drive ready
(without
drive
modules)
Fully
congured
(with drive
modules)
Storwize V7000 2076-724
and Storwize V7000 2076-
U7B Control Enclosures with
24 drive slots
87 mm
(3.46 in.)
483 mm
(19.0 in.)
850 mm
(33.5 in.)
44.85 kg
(98.87 lb)
49.65 kg
(109.46 lb)
2076-92F Expansion
Enclosure with 92 drive slots
222.2 mm
(8.75 in.)
483 mm
(19.0 in.)
968 mm (38.1
in.)
67 kg (147.7
lb)
135 kg (297
lb)
Warning: The 2076-92F model needs 968 mm from the rack front post to the back of the cable
management arm (CMA). Some racks do not provide sufcient space to close the rear door. In
addition, allow 905 mm from the front post to the back of the enclosure. To allow space for the
power cables, provide 60 to 70 mm from the back of the enclosure.
Figure 149 on page 152 shows the rack space requirements for the 2076-92F models.
Figure 149. Rack space requirements for the 2076-92F models
The following table shows the rack space requirements for the control enclosure in tabular form.
Table 26. Rack space requirements for the Storwize V7000 2076-724 or Storwize V7000 2076-U7B control
enclosure
Minimum rail length Maximum rail depth
685 mm (27 in.) 765 mm (30.1 in.)
Additional space requirements
152
Storwize V7000 : Gen3 Quick Installation Guide for MTM 2076-724, 2076-U7B, 2076-12F, 2076-24F, and
2076-92F