IBM System Storage TS3400 Tape Library - Page 25

Chapter 1. Start Service 1-9
007C
In GET (remove cartridge
from drive) operation,
cartridge cannot be ejected
because the drive does not
enter EJECT state after 200
seconds have elapsed.
CHK 007C
1. Cycle the power and try again.
2. Check for presence of media in the drive.
3. Replace the media.
4. Replace the Library Control Blade (page 9-8).
5. Replace the drive canister (page 9-11).
6. Replace the Drive Docking Card (page 9-19).
7. Replace the Back Board assembly (page 9-37).
8. Replace the TS3400 Tape Library chassis (page 9-44).
007D
In PUT (put cartridge into
drive) operation, cartridge
cannot be put because the
drive does not enter
MOUNT state after 200
seconds have elapsed.
CHK 007D
1. Cycle the power and try again.
2. Check for presence of media in the drive.
3. Replace the media.
4. Replace the Library Control Blade (page 9-8).
5. Replace the drive canister (page 9-11).
6. Replace the Drive Docking Card (page 9-19).
7. Replace the Accessor assembly (page 9-23).
8. Replace the Accessor Flat Cable Plate assembly (page 9-28).
9. Replace the Back Board assembly (page 9-37).
10. Replace the TS3400 Tape Library chassis (page 9-44).
007E
In PUT (put cartridge into
drive) operation, the drive
does not enter SET state
after 3 seconds have
elapsed.
CHK 007E
007F
In PUT (put cartridge into
drive) or GET (remove
cartridge from drive)
operation, the assigned
drive and interface
communication fails or is
disconnected.
CHK 007F
1. Confirm the drive connection.
2. Cycle the power and try again.
3. Replace the Library Control Blade (page 9-8).
4. Replace the drive canister (page 9-11).
5. Replace the Drive Docking Card (page 9-19).
6. Replace the Back Board assembly (page 9-37).
7. Replace the TS3400 Tape Library chassis (page 9-44).
0080
X movement error #1.
During X movement, an
error occurred in the
target stop position’s
origin sensor detection.
CHK 0080
1. Cycle the power and try again.
2. Replace the Library Control Blade (page 9-8).
3. Replace the Accessor assembly (page 9-23).
4. Replace the Accessor Flat Cable Plate assembly (page 9-28).
5. Replace the Back Board assembly (page 9-37).
6. Replace the TS3400 Tape Library chassis (page 9-44).
0081
X movement error #2.
During X movement, the
motor lost sync with
commanded position.
CHK 0081
1. Cycle the power and try again.
2. Replace the Library Control Blade (page 9-8).
3. Replace the Accessor assembly (page 9-23).
4. Replace the Accessor Flat Cable Plate assembly (page 9-28).
5. Replace the Back Board assembly (page 9-37).
6. Replace the TS3400 Tape Library chassis (page 9-44).
0082
X movement error #3.
During initialization, the
motor lost sync with
commanded position.
CHK 0082
0083
During removal of
cartridge from a drive and
transferring it to a storage
slot, the X origin sensor
could not be detected.
CHK 0083
0084
During initialization, the
X origin position could
not be detected.
CHK 0084
Table 1-1. Library error codes (continued)
Code (H) Description
Panel
Indication
Action Required