EasyManua.ls Logo

IBM System Storage TS3400 Tape Library - Page 26

IBM System Storage TS3400 Tape Library
295 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1-10 TS3400 Tape Library Maintenance Information
0088
X calibration error #1.
During X calibration,
CTRG. sensor OFF could
not be detected.
CHK 0088
Cycle the power and try again.
0089
X calibration error #2.
During X calibration,
CTRG. sensor ON could
not be detected.
CHK 0089
008A
X calibration error #3.
During X (DRIVE)
calibration, CTRG. sensor
OFF could not be
detected.
CHK 008A
008B
X calibration error #4.
During X (DRIVE)
calibration, CTRG. sensor
ON could not be detected.
CHK 008B
008F
During X operation, a
cartridge magazine was
removed.
CHK 008F
1. Confirm the magazine is closed.
2. Cycle the power and try again.
3. Replace the Library Control Blade (page 9-8).
4. Replace the Back Board assembly (page 9-37).
5. Replace the TS3400 Tape Library chassis (page 9-44).
0090
Y movement error #1.
During Y movement, an
error occurred in the
target stop position’s
origin sensor detection.
CHK 0090
1. Cycle the power and try again.
2. Replace the Library Control Blade (page 9-8).
3. Replace the Accessor assembly (page 9-23).
4. Replace the Accessor Flat Cable Plate assembly (page 9-28).
5. Replace the Back Board assembly (page 9-37).
6. Replace the TS3400 Tape Library chassis (page 9-44).
0091
Y movement error #2.
During Y movement, the
motor lost sync with
commanded position.
CHK 0091
0092
Y movement error #3.
During initialization, the
motor lost sync with
commanded position.
CHK 0092
1. Cycle the power and try again.
2. Replace the Library Control Blade (page 9-8).
3. Replace the Accessor assembly (page 9-23).
4. Replace the Accessor Flat Cable Plate assembly (page 9-28).
5. Replace the Back Board assembly (page 9-37).
6. Replace the TS3400 Tape Library chassis (page 9-44).
0094
During initialization, the
Y origin position could
not be detected.
CHK 0094
0098
Y calibration error #1.
During Y calibration,
CTRG. sensor OFF could
not be detected.
CHK 0098
Cycle the power and try again.
0099
Y calibration error #2.
During Y calibration,
CTRG. sensor ON could
not be detected.
CHK 0099
Table 1-1. Library error codes (continued)
Code (H) Description
Panel
Indication
Action Required

Table of Contents

Related product manuals