ICE Vulcan Service Manual
Installation
This chapter contains the following topics:
•
Tools and Supplies
•
Unpacking and inspecting the labeller
•
Selection of a suitable installation position
•
Installing the label applicator
Caution
EQUIPMENT DAMAGE. Only ICE trained personnel must
carry out the installation and
maintenance work. Any such work
undertaken by unauthorized personnel can damage the
LPA and
invalidate the warranty.
Warning
PERSONAL INJURY. Make sure that the mains electrical supply is
within the range indicated by
the label adjacent to the mains inlet of
the labeller. If the voltage ratings differ, do not use the
labeller until
you consult your ICE supplier.
Use only the mains power cable supplied with the labeller. This
cable must terminate in an
approved, three-pole, mains plug which
has a protective ground conductor.
Keep electrical power cables, sockets and plugs clean and dry at all
times.
To Next Page
Loading...
Need help?
General