How to Configure the LPA 5-9
ICE Vulcan Service Manual
In a networked environment, system administrators could have direct
access to the LPA, while
line operators are limited to accessing only the
operating variables that are relevant to them.
How to Install the CLARiTY Configuration Manager
CLARiTY Configuration Manager is available in the CD with the Operator
Manual. To operate
the CD, the system requires Windows XP, NT or
Windows 7.0 operating system with minimum
5 MB capacity and ethernet
or serial port. The installation routine commences automatically.
Do the following tasks to install:
1
Insert the CD.
2
Click on the CD drive.
3
Select CLARiTY Configuration Manager on the CD Index. File
Downloads page
appears.
4
Run the CLARiTYConfig.exe file.
Follow the on-screen instructions to install the software. The software is
installed in the PC
and is ready for use.
How to Connect the CLARiTY Configuration Manager to the LPA
Note: When you connect the CLARiTY Configuration Manager to the LPA, the
first connection
must be done using an RS232 connection.
How to Connect the CLARiTY Configuration Manager to the LPA
using an RS232 connection
Do the following tasks to connect the CLARiTY Configuration Manager to
the LPA:
1
Connect the PC serial port to the main controller board using the null-
modem cable.
2
Ensure that all other programs (such as, Active sync and other PDA
applications) that use
the serial port are disabled.
To Next Page
Loading...
Need help?
General