Installing the Label Applicator 4-6
ICE Vulcan Service Manual
Installing the Label Applicator
The following procedure explains the installation of the Vulcan
Label Applicator on a
production line.
Assembling the Stand
Do the following procedure to assemble the Stand.
Note: This procedure explains a typical horizontal left hand configuration. A
different
configuration may require a different stand. Make sure the installation is
completed as per the
requirement.
Note: Additional stand instructions are available for different configurations.
1
Remove the stand from the packaging in an area with sufficient room
to build the stand
close to the final production location.
To Next Page
Loading...
Need help?
General