5-20 How to Configure the LPA
ICE Vulcan Service Manual
8
Close the CLARiTY Configuration Manager software.
9
Remove the USB memory stick from the computer.
Restoring the Archive to the LPA
Do the following tasks to restore the archive to the LPA:
1
Insert the USB memory stick containing the desired archive into the
LPA’s USB port.
2
Navigate to Tools > Setup > Control > CLARiTY Parameter Archives.
3
Locate the desired archive from the list on the screen and select it.
4
Select the Restore Archive button at the bottom of the screen.
5
Select Yes if you are sure that you want to continue with the restore
process after
reading the message on the LPA’s screen
6
Select Yes or No depending on whether or not you want to restore the
network settings
from the archive.
7
Select Yes or No depending on whether or not you want to restore the
password settings
from the archive.
8
Once the screen indicates the Archive was restored successfully, press
OK.
To Next Page
Loading...
Need help?
General