Icom IC-2710H

1
PANEL DESCRIPTION
6
■ Microphone
LOCK
VFO
CALL
MR
SUB
BAND
MW
FUNC
A
CLR
D-OFF
B
SET
PTT-M
3
PRIO
DTMF
6
LOW
AFC-OFF
2
SCAN
CSQL
5
MID
AFC
1
MONI
PGR
4
HIGH
T-OFF
C
ENT
TSQL
9
SIMP
16 KEY LOCK
#
TSQLS
8
DUP+
TONE-2
0
TONE
7
DUP
TONE-1
F-2
F-1
DTMF-S
MUTE
D
SQLSQLVOLVOL
Mic element
q
w
e
r
t
y
u
i
o
q UP/DOWN SWITCHES [Y]/[Z]
➥ Push either switch to change the operating frequency,
memory channel, set mode contents, etc. (pgs. 17, 32)
➥ Push and hold either switch to start scanning. (p. 42)
w PTT SWITCH
➥ Push and hold to transmit; release to receive. (p. 25)
➥ Toggles between transmitting and receiving while the
one-touch PTT function is in use. (p. 26)
e VFO SWITCH [VFO(LOCK)]
➥ Push to select VFO mode.
➥ Push and hold to toggle the lock function ON and OFF.
r MEMORY SWITCH [MR(CALL)]
➥ Push to select memory mode. (p. 32)
➥ Push and hold to select the call channel. (p. 37)
t ACTIVITY INDICATOR
Lights red while a key is pushed; lights green while the
one-touch PTT function is in use.
y BAND SWITCH
➥ Push to toggle the main band. (p. 15)
➥ Push and hold to turn the sub band access function ON
and OFF. (p. 22)
u FUNCTION SWITCHES [F-1]/[F-2] (p. 74)
Assign your desired key function from the front panel
switches.
• Default settings are VHF and UHF tuning dials to [F-1] and [F-2],
respectively for quick band selection.
i FUNCTION INDICATOR
➥ Lights yellow while [FUNC] is activated—indicates the
secondary function of switches can be accessed.
➥ Lights green when [DTMF-S] is activated—DTMF sig-
nals can be transmitted with the keypad. (p. 51)
o KEYPAD
Used for controlling the transceiver, transmitting a DTMF
encoder, etc. See pgs. 7 and 8 for function details.
IC-2710H.qxd 02.2.8 16:55 Page 6 (1,1)