ii
UNPACKING
Accessories included with the transceiver:
Qty.
➀ DC power cable (OPC-346)............................................. 1
➁ Mobile mounting bracket ................................................. 1
➂ Microphone (HM-98)........................................................ 1
➃ Fuse (20 A)...................................................................... 1
➄ Knob bolt (M4 x 8) ........................................................... 4
➅ Mounting bolt (M5 x 12)................................................... 4
➆ Nut (M5)........................................................................... 4
➇ Spring washer (M5) ......................................................... 4
➈ Flat washer (M5).............................................................. 4
➉ Self-tapping screws (A0 5 x 16)....................................... 4
DO NOT allow children to play with any radio equipment
containing a transmitter.
During mobile operation,
DO NOT operate the transceiver
without running the vehicle’s engine. When transceiver power
is ON and your vehicle’s engine is OFF, the vehicle’s battery
will soon become exhausted.
BE CAREFUL! The transceiver will become hot when
operating it continuously for long periods.
AVOID using or placing the transceiver in areas with tem-
peratures below –10°C (+14°F) or above +60°C (+140°F) or
in areas subject to direct sunlight, such as the dashboard.
AVOID the use of chemical agents such as benzine or al-
cohol when cleaning, as they can damage the transceiver
surfaces.
USE Icom microphones only (supplied or optional). Other
manufacturer’s microphones have different pin assignments
and may damage the transceiver.
To Next Page
Loading...
