3
SETTING A FREQUENCY
17
■ Using a tuning dial
➀ Rotate the desired band’s tuning dial to set the frequency.
• If VFO mode is not selected, push the same band’s [V/MHz] to
select VFO mode.
• Frequency changes according to the selected tuning steps.
(p. 18)
➁ For the 1 MHz frequency setting, rotate the same band’s
tuning dial after pushing [V/MHz].
• Pushing [V/MHz] for 1 sec. starts a scan function. If this happens,
push [V/MHz] again to stop the scan.
D 10 MHz steps
Some versions have 10 MHz tuning steps. For these versions
the [V/MHz] switch selects 10 MHz, 1 MHz then kHz steps in
sequence.
■ Using [Y]/[Z] switches
Push [Y] or [Z] to set the main band’s frequency.
• If VFO mode is not selected, push [VFO] to select it.
• Frequency changes according to the selected tuning
steps. (p. 18)
• Pushing [Y] or [Z] for more than 0.5 sec. activates a
scan. If this happens, push [Y] or [Z] again to stop it.
NOTE: 1 MHz steps cannot be used via the [Y]/[Z]
switches
To Next Page
Loading...
