Icom IC-2710H

2
INSTALLATION
11
■ Microphone connection
The microphone connector is located behind the front panel.
Connect the supplied microphone as follows:
➀ Push the release button, then detach the remote controller
as shown below.
➁ Connect the supplied microphone to the microphone con-
nector.
➂ Reattach the remote controller to the main body.
➃ To remove the microphone, push the release button as
above.
■ Separate installation
Using an optional OPC-600/601 SEPARATION CABLE
, the front
panel can be separated from the main body, doubling as a re-
mote controller.
➀ Detach the front panel as shown at left.
➁ Connect a separation cable to the front panel and to the
main body using the supplied screws as illustrated below.
mic release
Push
Release
button
OPC-600 or OPC-601
Rear of front panel Main body
➀ 8 V OUT
➁ Freq. up/down
➂ 8 V control IN
➃ PTT
➄ Mic AF (–)
➅ Mic AF (+)
➆ Ground
➇ Data IN
➇➀
Microphone pin assignments
IC-2710H.qxd 02.2.8 16:55 Page 11 (1,1)