CALL CHANNEL OPERATION
7
37
■ Calling up a call channel
Each band has an independent call channel to store a most-
often-used frequency for quick recall.
➀ Push the desired band’s [M/CALL] once or twice to display
a large “C” in the memory channel readout.
• To transmit on the call channel, select the desired band as the
main band in advance.
➁ Push the same band’s [V/MHz] or [M/CALL] to exit the call
channel.
Ä Push [BAND] to select the desired band, if nec-
essary.
Å Push [(MR)CALL] for 1 sec. to select the call
channel.
■ Transferring call channel
contents
➀ Push the desired band’s tuning dial.
➁ Select the call channel by pushing the selected band’s
[M/CALL] once or twice.
• A large “C” appears.
➂ Push [S.MW] momentarily, then rotate the tuning dial to se-
lect another memory channel to transfer.
• To transfer to the VFO, push and hold [(S.MW)MW] instead of
pushing momentarily.
➃ Push and hold [(S.MW)MW] to transfer when a momentary
push was used in the previous step.
Ä Push [BAND] to select the desired band, if nec-
essary.
Å Push [(MR)CALL] for 1 sec. to select the call
channel.
Ç Push [FUNC], then [EMW] momentarily.
• To transfer to the VFO, push [FUNC] then [EMW] in-
stead of pushing [EMW] momentarily.
É Push [FUNC] then [EMW] for 1 sec. to transfer
when momentarily pushing [EMW] in step ➂.
To Next Page
Loading...
