Icom IC-2710H

9
SCAN OPERATION
44
■ Programming scan edges via
the microphone
Ä Push [BAND] to select the desired band, if nec-
essary.
Å Set the desired frequency in VFO mode:
➥ Push [VFO] to select VFO mode.
➥ Set the frequency using the keypad.
Ç Push [FUNC] then [EMW] momentarily.
É Push [Y] or [Z] to select scan edge channels.
Ñ Push [FUNC] then [EMW] for 1 sec. to pro-
gram.
[EXAMPLE]: Programming 145.30 MHz and 145.80 MHz for the VHF scan edges 1A and 1b.
159
159159
Push Push then
momentarily
Program 1b
in the same
manner.
PushPush for 1 sec. and
continue pushing
VFO
3
PRIO
0
VOL
5
MID
1
MONI
4
HIGH
C
A
ENT
MW
FUNC
A
CLR
then
MW
FUNC
CLR
Y
➥ 3 beeps may sound and the VFO contents (including the sub-
audible tone frequency, etc.) are programmed.
➥ Memory channel number advances to the next scan edge chan-
nel (1b to 3b) when continuing to push [EMW] after program-
ming.
Ö To program a frequency for the other scan edge channel,
repeat steps Å
and Ñ.
MW
A
IC-2710H.qxd 02.2.8 16:55 Page 44 (1,1)