OTHER FUNCTIONS
17
72
■ Beep tones on/off
You can select silent operation by turning beep tones OFF or
you can select to have confirmation beeps sound at the push
of a switch by turning beep tones ON.
➀ Push power to turn power OFF.
➁ While pushing [(VOL)
SET L], turn power ON to enter initial
set mode.
➂ Push [(VOL)
SET L] one or more times until “bEP” appears.
• Pushing [(SQL)MONI] reverses the order of selection.
➃ Rotate the left-hand tuning dial to select the condition.
•“bEP-oF”: Beep tones are turned OFF.
•“bEP-on”: Beep tones are turned ON.
➄ Push [POWER] momentarily to exit initial set mode.
■ Time-out timer
To prevent accidental prolonged transmission with the one-
touch PTT function, etc., the transceiver has a time-out timer.
This timer cuts a transmission OFF after 3, 5, 15 or 30 min. of
continuous transmission. This timer can be cancelled (de-
fault).
Approx. 10 sec. before the time-out timer passes, the trans-
ceiver emits a beep tone as a warning.
➀ Push [POWER] to turn power OFF.
➁ While pushing [(VOL)SET L], turn power ON to enter initial
set mode.
➂ Push [(VOL)SET L] one or more times until “tot” appears.
• Pushing [
(SQL)MONI] reverses the order of selection.
➃ Rotate the left-hand tuning dial to select the desired time-
out time or turn the timer OFF (“oF”).
➄ Push [POWER] momentarily to exit initial set mode.
USING
INITIAL SET MODE
USING
INITIAL SET MODE
To Next Page
Loading...
