POCKET BEEP AND TONE SQUELCH
12
53
Ä Push [BAND] to select the desired band, if nec-
essary.
Å Set the operating frequency.
Ç Program the subaudible tone frequency in set
mode.
• See p. 29 for programming details.
É Push [FUNC] then [➇T SQLS] to turn the
pocket beep ON.
• Turn OFF the pager or code squelch to activate the
pocket beep. (pgs. 59, 62) The pocket beep cannot
be used with the pager or code squelch.
Ñ When a signal with the correct tone is received,
the transceiver emits beep tones for 30 sec.
and flashes “S.”
Ö Push [PTT] to answer or push [ECLR] to stop
the beeps and flashing.
• Tone squelch is automatically selected.
• Pushing [FUNC] then [➈TSQL] also selects the tone
squelch.
Ü To cancel the function, push [FUNC] then
[GT-OFF].
D Waiting for a call from a specific station
A subaudible tone matched with the stations frequency is
necessary. Use the tone squelch on the next page or a sub-
audible tone encoder (p. 29).
■Pocket beep operation
This function uses subaudible tones for calling and can be
used as a “common pager” to inform you that someone has
called while you were away from the transceiver.
To operate the pocket beep function, an optional UT-104 is
necessary. See p. 65 for installation details.
D Waiting for a call from a specific station
➀ Push the desired band’s tuning dial.
➁ Set the operating frequency.
➂ Program the subaudible tone frequency in set mode.
• See p. 29 for programming details.
➃ Push [(DTMF)T] for 1 sec., 2 times to indicate “T SQLS”
in the function display.
• Turn OFF the pager or code squelch to activate the pocket beep.
(pgs. 59, 62) The pocket beep cannot be used in combination
with the pager or code squelch.
➄ When a signal with the correct tone is received, the trans-
ceiver emits beep tones and flashes “S”.
• Beep tones sound for 30 sec. To stop the beeps manually, push
the tuning dial (or any key).
•“S” flashes coninuously until step ➅ or ➆.
• When receiving another call while “S” is flashing, no beeps sound.
➅ Push [PTT] to answer.
• Tone squelch is automatically selected when transmitting.
➆ Push [(DTMF)T] for 1 sec. once or twice to cancel the function.
To Next Page
Loading...
