Icom IC-2710H

4
BASIC OPERATION
23
■ Sub band mute/
sub band busy beep
The sub band mute function automatically cuts out sub band
AF signals when both main and sub band signals are re-
ceived simultaneously.
The sub band busy beep sounds when the sub band’s
squelch is closed to inform you that the sub band’s squelch
has been opened.
➀ While pushing [(VOL)SET L] (on the left side of the trans-
ceiver), push [POWER] to enter initial set mode.
➁ Push [SET] one or more times until “Sub” appears in the
display as shown above.
• Push [MONI] to reverse the order of selection.
USING
INITIAL SET MODE
The display shows that the sub
band mute is turned ON and
the sub band busy beep is
turned OFF.
Common setting for each band
➂ Rotate the main band’s tuning dial to set the condition.
➃ Push [POWER] momentarily to exit initial set mode.
DISPLAY SUB BAND MUTE BUSY BEEP
Sub-oF OFF OFF
Sub-oF S
OFF ON
Sub-on ON OFF
Sub-on S
ON ON
IC-2710H.qxd 02.2.8 16:55 Page 23 (1,1)