Icom IC-2710H

11
DTMF MEMORY ENCODER
50
■ Programming a DTMF code via the microphone
[EXAMPLE]: Programming “5428AB453” into DTMF memory channel “d4.”
DTMF codes can be directly programmed via the
keypad on the microphone. The contents can be
overwritten, but cannot be cleared via the micro-
phone. See the page at left for clearing the con-
tents.
Ä Push [FUNC] then [➅DTMF] to turn the DTMF memory
function ON.
•“d” appears in place of the 100 MHz digit.
Å Push [FSET] to enter the programming condition.
Ç Push [Y] or [Z] to select the desired channel.
DTMF
6
É Push the desired digit keys.
• When the first digit is input, previous memory contents are
cleared automatically.
•“E” stands for “M” and “F” stands for “#.”
• Push [Y] then [Z], and repeat this step when making a mistake.
• The S/RF indicator shows the digit group. The indication in-
creases every 6 digits.
Ñ Push the [BAND] to exit the programming condition.
• The [ECLR] key cannot be used to exit. If pushed, “A” is input,
and the previously programmed data is erased. Reprogram again
in such a case.
Push
8
DUP+
5
MID
5
MID
4
HIGH
4
HIGH
A
CLR
then
FUNC
DTMF
6
LOW
B
SET
B
SET
2
SCAN
3
PRIO
BAND
IC-2710H.qxd 02.2.8 16:55 Page 50 (1,1)