5
REPEATER OPERATION
31
■ Auto repeater
(U.S.A. version only)
The U.S.A. version automatically activates the repeater set-
tings (DUP or DUP– and tone encoder ON/OFF) when the
operating frequency falls within the general repeater output
frequency range and deactivates them when outside of the
range.
D Setting the auto repeater function ON/OFF
➀ Push [POWER] to turn power OFF.
➁ While pushing [(VOL)
SET L] (left side), turn power ON to
enter initial set mode.
➂ Push [SET L] one or more times until the “rPt” display ap-
pears as shown below.
➃ Rotate the left-hand tuning dial to turn the auto repeater
function ON (“rPt-r1” or “rPt-r2”) or OFF (“rPt-oF”).
•“rPt-r1” and “rPt-r2” automatically set the duplex setting and du-
plex/tone encoder settings, respectively.
➄ Push [POWER] momentarily to exit initial set mode.
USING
INITIAL SET MODE
D Frequency range and offset direction
FREQUENCY RANGE DUPLEX DIRECTION
145.200–145.495 MHz
146.610–146.995 MHz
“DUP–” appears
147.000–147.395 MHz “DUP” appears
442.000–444.995 MHz “DUP” appears
447.000–449.995 MHz “DUP–” appears
IC-2710H.qxd 02.2.8 16:55 Page 31 (1,1)
To Next Page
Loading...
