Icom IC-2710H

9
SCAN OPERATION
43
■ Programming scan edges
Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into pairs of
scan edge channels, 1A/1b to 3A/3b, in memory channels.
➀ Push the desired band’s tuning dial.
➁ Set the desired frequency in VFO mode:
➥ Push the selected band’s [V/MHz] to select VFO mode.
➥ Set the frequency using the selected band’s tuning dial.
➥ Set other data (e.g. offset frequency, etc.) if required.
➂ Push [S.MW] momentarily.
•“!” and the memory channel number flashes.
[EXAMPLE]: Programming 145.30 MHz and 145.80 MHz for the VHF scan edges 1A and 1b.
159
159
S.MW MW
Push
VHF
tuning
dial.
then rotate
Rotate
Push
momentarily
S.MW MW
S.MW MW
Push
and hold
continue pushing
Program 1b in the same manner.
➃ Rotate the tuning dial to select a scan edge channel (1A to
3A).
➄ Push [(S.MW)MW] for 1 sec. to program.
• 3 beeps may sound and the frequency is programmed.
• Scan edge 1b is automatically selected when continuing to push
[(S.MW)MW] after programming.
➅ To program a frequency for the other pair of scan edges,
1b to 3b, repeat steps ➃ and ➄.
• If the same frequency is programmed into both scan edges, pro-
grammed scan will not function.
IC-2710H.qxd 02.2.8 16:55 Page 43 (1,1)