Icom IC-2710H

9
SCAN OPERATION
45
■ Skip channel setting
The memory skip function speeds up scanning by checking
only desired memory channels. Set the memory channels to
be skipped or scanned as follows.
➀ Push the desired band’s tuning dial.
➁ Select the memory channel to program or to cancel the
skip function on:
➥ Select memory mode by pushing the selected band’s [M/CALL]
once or twice.
➥ Rotate the selected band’s tuning dial to select the memory
channel.
➂ Push [SET] one or more times until “CHS” appears as
shown above.
• Pushing [MONI] reverses the order of selection.
➃ Rotate the selected band’s tuning dial to turn the skip func-
tion ON or OFF on the selected channel.
•“~” appears : The memory channel is skipped during
(CHS-on) memory scan.
•“~” disappears : The memory channel is scanned during
(CHS-OFF) memory scan.
USING
SET MODE
Separate setting for each band
SKIP
The display shows that VHF
memory channel 10 is set as
a skip channel.
➄ Push the selected band’s tuning dial to exit set mode.
NOTE: Scan edge memory channels cannot be specified
as skip channels, however, they are skipped during mem-
ory scan anyway.
Ä Push [BAND] to select the desired band, if nec-
essary.
Å Select the memory channel to program or to
cancel the skip function on:
➥ Select memory mode by pushing [MR].
➥ Push [Y] or [Z] to select a memory channel.
Ç Push [FSET] one or more times until “CHS” ap-
pears as shown at left.
• Pushing [GENT] reverses the order of selection
once entering set mode.
É Push [Y] or [Z] to set or cancel the skip infor-
mation.
• See item ➃ at left for skip indicator details.
Ñ Push [ECLR] to exit set mode.
SET
B
IC-2710H.qxd 02.2.8 16:55 Page 45 (1,1)