13
PAGER AND CODE SQUELCH
62
Ä Push [BAND] to select the desired band, if nec-
essary.
Å Set the operating frequency.
Ç Push [FUNC] then [➄C SQL] to turn the code
squelch ON.
•“C” appears in place of the 100 MHz digit.
• An optional tone squelch can be used together with
the code squelch. (p. 54)
É Select the desired code channel:
➥ Push [FSET].
➥ Push [Y] or [Z] to select the code channel.
➥ Push [ECLR] to exit the setting display.
Ñ Operate the transceiver in the normal way
(push [PTT] to transmit; release [PTT] to re-
ceive).
• Prior to voice transmission, a 3-digit transmit code
is sent each time [PTT] is pushed in order to open
the receiving station’s code squelch.
Ö To cancel the code squelch push [ECLR].
• Pushing [FUNC] then [FD-OFF] also cancels the
code squelch.
■ Code squelch operation
➀ Push the desired band’s tuning dial.
➁ Set the operating frequency.
➂ Push [DTMF] 3 times to turn the code squelch ON.
•“C” appears in place of the 100 MHz digit as shown below.
• An optional tone squelch can be used together with the code
squelch, although the pocket beep cannot be used. (p. 54)
➃ Select the desired code channel:
➥ Push [SET].
➥ Rotate the selected band’s tuning dial to select the code chan-
nel.
➥ Push the selected band’s tuning dial to exit the setting display.
➄ Operate the transceiver in the normal way (push [PTT] to
transmit; release [PTT] to receive).
• Prior to voice transmission, a 3-digit transmit code is sent each
time [PTT] is pushed in order to open the receiving station’s code
squelch.
➅ To cancel the code squelch, push [DTMF] once (or 2 times
for the U.S.A. version).
• The display shows the operating frequency.
To Next Page
Loading...
